Small Vacuum Plate

This small standalone vacuum plate, recommended for series II towers, is used to increase the in holding power and stability. It can be used on the front stabilizer foot on Intelli-Towers or placed behind the tower and attached to the D-ring with a strap. Also, can be used in the opposite side of the vehicle you are pulling on to anchor it, so it does not side under pull. Another use is to upgrade your underperforming tower with this plate attached to the back of tower to get more pull power. Caution is advised, your tower upright and pulley system may not withstand the increase in anchoring power.  Sold as stand alone, with an air powered vacuum generator or both. Make sure to order the front plate vacuum line kit if to be used on front stabilizer so tower pump can provide vacuum. no other vacuum source needed with this kit. Works only on front foot. 

This Plate also works great for A hood stand and/or a table hold down to stabilize the stand so it doesn't move or lift when working a panel 

NOTE: shipping ground to lower 48 states only, make take 1-2 week delivery depending on stock levels.

Specs

       Plate is 10 x 10, made from .5-inch aluminum plate. \

        Vacuum surface, 8 x 8, 64 square inches

       Atmospheric pressure @ 28Hg   = 896 lb. of down force

       Durable rubber seal